Z position after corner probing 10mm above where it should be
Hi, I’ve looked through the questions but can’t see a query for the following.
After successfully corner probing using the touch probe, I set XYZ work zero and home/jog away but when I click Go to work XYZ Zero, X and Y are correct but Z is 10mm above the corner position. It worked for a few runs initially but since running WorkBee-Firmware-v1.0.7 it has always been out on the Z access. Is there a setting in the software that may need changing? The probe settings are default and confirm to the dimensions of the probe.
Many thanks for your help.
Dan
Is this a worthwhile discussion?