Skip to main content


Minor Versionm

by Ryan Lock

  1. If you are connecting the Duet via Ethernet directly to your computer, please follow our YouTube Video:
    • Insert wisdom here.


Thanks for following the guide. Any issues, please contact us!

Ryan Lock

Member since: 04/11/2018

8 Guides authored


OK where are the words of wisdom for the firmware upgrade. Do I need to upgrade to the Workee F/W instead of the Duet F/W or are they the same. If so why don’t the rev numbers tally.

The Duet controller I have says it is running F/W rev RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.01(RTOS) ELECTRONICS: Duet WiFi 1.02 or later FIRMWARE_DATE: 2018-07-26b2

Derek Hart - Reply

Hi Derek,

Thank you for your comment. The WorkBee Firmware includes the Duet firmware. You need to update everything. The WorkBee Firmware folder includes all the macros and configs which specifically with that Duet Firmware version.

Best Regards

Ryan Lock

Ryan Lock -

Not related to this topic but I could not find anywhere yo write it: you should consider drilling a simetrical hole for the wire feed of the z limit switch within the plate described at step 2.3.3 of the mechanical guide- x Acme nut blocks. Apparently I mounted the plate the other way arround and I can't feed the wire as per the instructions unless I undoo about 12 hours of installation. Either adjust the instruction to attract attention to this item or drill a symmetrical whole so it does not matter if the plate is mounted the other way arround. - Reply

Hi Gabriel,

Thank you for your feedback on the design on the machine. We will look into your suggested change of the design and see if we can implement it on future designs.

Best Regards

The Ooznest Team

Ryan Lock -

I just did exactly this and have manually drilled a rather fugly hole myself. This step is easily missed. Good suggestion

Tom Pain - Reply

Add Comment