Will take your advice. Will let everyone know if there is any issues in the future.
The fans are located over the wire harness. Makes air ventilation poorer and fitting packaging harder.
Motor wire 5 i very short. Give us 50 mm extra please :(
Limit switch 0 is too short for me. Had to route it through the air vents in the bottom of control unit.
Don’t push the sticker in the tracks when ‘removing’ it from extrusion B.
Exactly what we did. Then we used it for the limit switch before seeing the next step of pulling the touch probe wire through the drag chain….
My limit switch 1 is 1650 mm.
An improvement, first run a pilot wire through the drag chain. Then it will be easier pulling the complete harness through.
The drag chains are packed (rolled) with the Fixed End on the outer side. At least at this point.
To get the screw to enter the holder I entered it first and then loosen it and then dropped the router in. Otherwise difficult to get screw to thread.
Page 1 of 4
Next
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
Will take your advice. Will let everyone know if there is any issues in the future.
The fans are located over the wire harness. Makes air ventilation poorer and fitting packaging harder.
Motor wire 5 i very short. Give us 50 mm extra please :(
Limit switch 0 is too short for me. Had to route it through the air vents in the bottom of control unit.
Don’t push the sticker in the tracks when ‘removing’ it from extrusion B.
Exactly what we did. Then we used it for the limit switch before seeing the next step of pulling the touch probe wire through the drag chain….
My limit switch 1 is 1650 mm.
An improvement, first run a pilot wire through the drag chain. Then it will be easier pulling the complete harness through.
The drag chains are packed (rolled) with the Fixed End on the outer side. At least at this point.
To get the screw to enter the holder I entered it first and then loosen it and then dropped the router in. Otherwise difficult to get screw to thread.
Page 1 of 4
Next