Mr Glen Seagars

Hi Ryan

I have a 60 Deg bit how do you probe the corner , when i tried it the bit gos half way down the angle only so gives an incorrect centre.

Thanks Glen.

Hi Robert,

It was me pressing ‘Set Work Zero’ thanks for your help.

Probe top is on the job , as in turned over from normal use.

Hi guys i used the probe to set the height of the z axis only, set the work zero and when i ran the job the end mill ran about 10mm above the work peice. But if i set the height manualy on top of the job its fine. I take it you dont have to callibrat the probe.

Thanks Glen.