Help
Dylan Feeney
@dylanfeeney
Dylan Feeney
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 10/26/2023 | |
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 10/26/2023 | |
If you have the XYZ touch probe, now is a good time to test it. I bought the z1+ and the probe was not enable by default. I had to go into Settings, then Machine Specific and enable the touch probe. From there I clicked on "Reset to Defaults" to ensure the defaut settings were in place for the prove. I ran into trouble at a later stage trying to get this enabled as it is in some documentation but not others