Thanks Robert. Cheers
But the right file where to add M581 T0 E1 S1 and M582 T0 commands should be the 'config-user-settings.g' and not ‘customconfig.g’ ???
Why now in step 10 it is mandatory to use the 8mm-Lock-Collar instead of the 8mm-Clamping-Collar ?
Hi Ryan.
Which news on 1.0.7.3 firmware release ??
Hi Pete.
M42 P2 S1 turns ON the led
M42 P2 S0 turns OFF the led
M42 P2 S0.5 dims the led at 50%
M42 P2 S0.7 dims the led at 70%
I’m sorry but i think there is a little of confusion in this guide.
You are using the ‘H1 Terminal’ term to refer where to connect the led ring.
But on the board the printed label is ‘E1 Heat’.
So probably it is better if you substitute ‘H1 Terminal’ term with ‘E1 Terminal’ term.
Also it is a useful info if you specify that this port manages the Heater 2 on the Duet2 board (Heater 0 = Bed; Heater 1 = E0; Heater 2 = E1 )
Instead of to use the E1 terminal you can use one fan output so you can turn on/off and dim the led light
Exactly the same here. Practically no way to set the gaps
I have received a new set of eccentrics but unfortunately it is more or less the same !!!!
Could be a problem with the holes distances on the plates ??
Same exactly issue here
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.
Thanks Robert. Cheers
But the right file where to add M581 T0 E1 S1 and M582 T0 commands should be the 'config-user-settings.g' and not ‘customconfig.g’ ???
Why now in step 10 it is mandatory to use the 8mm-Lock-Collar instead of the 8mm-Clamping-Collar ?
Hi Ryan.
Which news on 1.0.7.3 firmware release ??
Hi Pete.
M42 P2 S1 turns ON the led
M42 P2 S0 turns OFF the led
M42 P2 S0.5 dims the led at 50%
M42 P2 S0.7 dims the led at 70%
Hi Ryan.
I’m sorry but i think there is a little of confusion in this guide.
You are using the ‘H1 Terminal’ term to refer where to connect the led ring.
But on the board the printed label is ‘E1 Heat’.
So probably it is better if you substitute ‘H1 Terminal’ term with ‘E1 Terminal’ term.
Also it is a useful info if you specify that this port manages the Heater 2 on the Duet2 board (Heater 0 = Bed; Heater 1 = E0; Heater 2 = E1 )
Instead of to use the E1 terminal you can use one fan output so you can turn on/off and dim the led light
Exactly the same here. Practically no way to set the gaps
I have received a new set of eccentrics but unfortunately it is more or less the same !!!!
Could be a problem with the holes distances on the plates ??
Same exactly issue here