Darren clark

Note to anyone else building this, don’t attach the nut blocks to one of the y plates as stated! There is a left and right plate..! Found this the hard way! by the square cut out there is a 10mm round hole one side and a larger one the other side set into the plate this needs to be on the outside! (Larger hole) for the bearing to sit into later! Found this out once I got to the y axis assembly! Had to completely dismantle it! Not clear at all!! Not impressed! Nor are these instructions for the upgrade of a 1500x1500 belt to screw drive loads of parts not shown!

waste of time stripping down rebuilding And now having to strip down again!