I have had an odd error using the Z probe in the 1.07 firmware. I have the probe connection in parallel with Z home switch, as the original configuration was documented for the probe.
I set the Z height, using the probe for the first tool for the job, it worked OK but when I changed the tool the Z probe produced this :
G0/G1; target position outside machine limits
The machine was at the work X,Y zero position when I did the tool change, any ideas as to what is going on?
I have just downloaded the new firmware, should there be some new instructions on installing it?
The Installation Notes has this comment
If you are updating from version 1.0.6 or older please follow this guide [invalid guide link]
which implied new instructions but the link is bad.
Are you not using the probe to set the Z? That would give a clearance for the start of the cut. I would normally jog the Z up by 5 mm after removing the probe plate.
I have not used a MAC to access the Duet, but it is just a Web front end, it should work in any Web browser. I have used Firefox and Chrome, no difference in what you can see or do.
I have just tried to upload the latest firmware, did the first two files OK but now I don’t have the upload file button. I have tried applying the update, not change, so tried restoring the factory defaults, still no upload file button.
I have been getting G2/G3 errors, thats why I came looking for any firmware updates
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
No reputation gained yet.