Help
Steve Johnston
@byteme
Steve Johnston
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 06/07/2020 | |
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 06/07/2020 | |
I think the instructions are correct - “…closest to the corner edge…” not the edge edge (IYKNWIM). In other words the holes closest to the angle of the bracket go against the V-Slot-2040-745mm.
IGNORE the bit about the bolts - the 50mm do fit!
If you purchased the touch probe as part of the kit, this is best done at stage 9 of the X-carriage Assembly.
NB - You don’t use the existing M5 Low Profile Bolts as they are too short - 2 x 50mm bolts are provided in the touch probe kit.