Pete Franklin

the Z sense needs to be plugged in now to as access with the fans on is limited

also worth noting the web interface version on the board supplied June 2020 is 1.22.6, not sure what version the guide is written for

i too am unable to find the touch probe setting… my firmware is 2.03 according to m115 through the g-code console! and this is AFTER uploading the workbee firmware download!

FIRMWARE_NAME: RepRapFirmware for Duet 2 WiFi/Ethernet FIRMWARE_VERSION: 2.03 ELECTRONICS: Duet Ethernet 1.02 or later FIRMWARE_DATE: 2019-06-13b2

my firmware does NOT look anything like the screen shot!

for starters my web screen is white!

there is also NO file management! i have “G-code files” which is empty

how accurate does this need to be? im on 24.3 v

on windows 10, after you click upload and find the file in the size folder, right click and select “open With” choose notepad

how do we know the current version of fireware? i dont know which set of instructions to use!!!

under general, the firmare reports 2.03!!! so do i need to down grade it to 1.07? seems strange!

i found more information including how to set the board up with DHCP here:

https://duet3d.dozuki.com/Guide/1.)+Gett...

so after not being able to get the network to connect, i followed the Duet3d manual here:

https://duet3d.dozuki.com/Guide/1.)+Gett...

which shows you how to set the board to use DHCP, i can now get into it on my network

does the power need to be in? i have setup the board as per the USB instructions, given it a new IP but that ip doesnt ping or give me the web interface?