Help
JSR Sculpt
@jsr
JSR Sculpt
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 11/10/2020 | |
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 11/10/2020 | |
Did the corner probe check and it completed the z touch but as it moved towards the y it failed to stop and I had to hit emergency stop?
Can you suggest a reason?
Hi Ryan
We followed the guide through adding the firmware to Duet and did all the tests which worked fine.
We downloaded Fusion 360 and designed a simple pocket cut tool path uploaded it and it worked fine.
Then we tried cutting simple shapes which worked in simulation but the machine homes first then goes to the start of the path does one pass and stops.
The screen shows this.
Bad Command G19 command is not supported.
G2/G3 No i or j or r parameter.
Are we just not getting our tool paths correct in fusion or do we need a different post processor other than gbrl?
Cheers
John
Instead of. Don’t connect the usb to your computer when you don’t need to. This should read from the start. Step1. To set up your Duet 2, Plug the micro usb cable into the controller with the power OFF. Connect the usb to your computer even if you are going to use a WiFi connection. Once set up is complete disconnect the usb. It would have saved us a great deal of time.