I’m new as well but heres one possible answer. Is the 1st pocket 1 only doing the edge in vcarve. You need to load each new pocket into the interface software one at a time i.e. load one, run it. Load next, run it…. especially if a tool change is required.
Did not see a solid blue light until after I connected the mains in the next step. Only had red and 1 green until that point.
“Then slide the a Aluminium-Spacer-40mm highlighted in Green over each bolt. “ - The highlight appears to be blue not green
This comment found in the X axis instructions would help here. I spent ages looking at the two instructions trying to understand how to do both…..
“WorkBee Kits may include different version drag chains, please refer to the correct drawings for assembly of the version supplied.”