Skip to main content
User avatar

Z axis crashing into materials after setting work zero

I jog the machine to a certain location. Jog it down so it JUST touches the surface of the material and then select ‘set work xyz'

I then move the z axis up 25mm so I can fit the dust shoe.

If I now press go to work zero. It xy and fine but z will plunge into the workpiece and not stop just touching the work piece.

This is before running any gcode so it's a controller setup issue but I can't figure this out.

Answer this question I have this problem too

Is this a good question?

Score 0
Add a comment

1 Answer

User avatar

For some reason today this issue has self rectified.

Was this answer helpful?

Score 0
Add a comment

Add your answer

Author avatar Mike Adams will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 50