I have set dewalt router - chuck flush to the bottom of the z alumuninium profile. Turned off the work bee then manually wound to top of Z, turned on the workbee controller and set z, but when I wind it down using controller to test it doesn't return to home at top so I don't have room to add bits. Is it possible to book a telephone help slot?
Is this a good question?
Hi Paul,
Can you check your Z Limit Switch is triggering correctly please, as per our guide here: 2. Testing Your WorkBee
Please contact us on our help page, we will be able to assist you there: https://ooznest.co.uk/help/
Thanks.
Was this answer helpful?
Kimberley, Thank you for the prompt reply, I tried again this morning and it all worked correctly, I will follow the testing work bee guide anyway to help in my learning curve.
best regards
Paul
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 2
Past 30 Days: 3
All Time: 49
