I have an issue with my Workbee Z1+ machine. Been working fine the last couple of months but all of a sudden when trying to home X,Y and Z it will not go back to start position, leaving it in the middle of the machine. Please can someone assist me with this. Much appreciated.
Is this a good question?
Hi Martin,
I can see you also had a ticket with us and spoke to a technical team member, where it was discovered one or more of your limit switches were not working properly and therefore replaced under warranty.
If you have any other issues or questions, please do let us know at - https://ooznest.co.uk/help/
Thanks.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 31
