Skip to main content

v1.0

Major VersionM

by Robert

Introduction

Please read before proceeding to avoid damaging the controller and voiding your warranty

  1. Avoid connecting the Duet via USB when you do not need to. (Except when instructed to in the guides)
  2. Always unplug the WorkBee Power Supply before connecting the USB Cable.
  1. Do not follow this guide if you have the Ethernet version of the Duet. Please skip to this guide: 1. Connecting your Duet to a Network - Ethernet Download the USB drivers for Duet here and extract the files to a suitable location.
    • Do not follow this guide if you have the Ethernet version of the Duet. Please skip to this guide: 1. Connecting your Duet to a Network - Ethernet

    • Download the USB drivers for Duet here and extract the files to a suitable location.

    • Connect the Duet to your PC with the USB cable provided. Do not connect the power supply at this stage.

    • Normally on windows it will automatically install default drivers, and get the device ready for use.

    • Either way open Device Manager by pressing Windows Key + R and type devmgmt.msc, or launch from the Start menu by typing "Device Manager".

    • If the default drivers were installed it will show as a COM port under the 'Ports (COM & LPT)' section.

    • If windows didn't automatically install the drivers look for any devices with a yellow triangle which would indicate that the driver is not installed. These would normally show in the section highlighted in red in image 2.

    • Either way we need to install the Duet Manufacturer Drivers. Right click on the device. Click Update/Install Driver and browse to the folder of the driver that was downloaded at the beginning of this step. Continue setup by clicking "Next" until the device driver has been installed.

  2. Download and Install YAT here. Open YAT and go to -  File -> Close all terminals. Go to File -> Open Terminal
    • Download and Install YAT here.

    • Open YAT and go to - File -> Close all terminals.

    • Go to File -> Open Terminal

    • Configure the correct COM port, changing the Bits per Second to 115200.

    • Once configured press OK to connect to your Duet.

    • If unsure of the COM port number, press Windows Key + R on your keyboard and type devmgmt.msc

    • Your Duet will be listed under Ports (COM & LPT) as USB Serial Device (COM#) or similar. Use COM# as the com port in YAT.

  3. After the COM port has been configured, type the command "M115" and press enter to send it to the Duet board.
    • After the COM port has been configured, type the command "M115" and press enter to send it to the Duet board.

    • The Duet will return the firmware version being used confirming the connection to the Duet.

    • Leave the USB Cable plugged in and YAT open for the next guide.

Conclusion

Thanks for following the guide. Any issues, please contact us!

10 other people completed this guide.

Ryan Christy

Member since: 10/31/2018

19,971 Reputation

100 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 0

Past 7 Days: 8

Past 30 Days: 38

All Time: 2,953