Feeding the wire and cable tie is possibly the hardest step of the whole assembly so far! Could this step be moved to before the Z assembly is put onto the C beam? And feeding the wire through the cable chain before feeding the motor wire?
Reputation over time
It looks like this user hasn't gained any reputation yet.
Once they have, you'll be able to view a graph of their reputation gained over time.
Here's a preview of what the graph will look like:
If you have the touch probe, you might wish to feed through that cable too. And the Z-axis limit switch cable.
I couldn’t find a cable with the connector in the picture. My cable had the male end (to connect to the PSU) and bare wires on the other end.
Also, if you have a long enough network cable, you might wish to pull that through at this point too.
just realised, they’re marked in the previous step, in pink
I think you need to plug in and switch on the PSU first
where should we run the ethernet cable? Also through the cable chain, but then where?
Also, where is that ‘Always On’ fan connection?
Also, the bottom right bolt and nut gently touch the brown fuse on the board. This doesn’t look right, have I got it wrong?
run the wire through the hole in the backing board first?
run the cables through the slots on the PCB backing 3D print first before plugging in?
Feeding the wire and cable tie is possibly the hardest step of the whole assembly so far! Could this step be moved to before the Z assembly is put onto the C beam? And feeding the wire through the cable chain before feeding the motor wire?