Michael Clair

Turn the PSU on .

You’ll find the voltage under the “MACHINE STATUS “ tab, top right of Web Control, “sensors”, Vin.

I had to disable my Norton Anti Virus for this to work.

I had to disable my Norton Anti Virus for this to work.

I fitted 2 precision shims to each screw to move it away from the brown fuse

I fitted only 2 bottom corner brackets to the router mount and fitted it to the Z carriage. After making sure it was square, I then fitted the top corner brackets and then re adjusted the bottom two.

I have a 750x1000 machine and I found the centre of the V-Slot 2040- 665mm to be 147.5mm (to be precise) from each end of the larger extrusion.

As my previous comment, I found it easier to fit the T-Nuts to the brackets ( holes that run down the centre) and then slide them into the extrusion ( edge where there is only one channel)

You will see on the bracket that on one side the holes are close to the edge and the other side run down the middle. The holes that run down the middle will go against the extrusion. I removed the plate from one end, fitted the t-nuts to the bracket and slid them from one end.

rotate the Z carriage to the bottom (furthest away from the stepper motor and then with a torch you will see the grub screw( long allen key needed)