OK - up to now - Just testing the X jog. I notice that the RHS (when viewed from the router side (front)) stepper motor red LED next to the 4-way out cable is not lit (the other three are) and the X gantry only moves on the LHS. (I’m only using small +/- jogs here to make sure I don’t damage anything). I also notice that, when, the duet is off, I can rotate both X screw drives gently by hand. When the Duet is on both seem to be locked. Is there anything I can do to test/rectify this? - do you need any further info?
Quick follow-up on limit switches: I note switches are already wired up - great! Is there any significance in the differing wiring lengths? E.g. Shortest -> Z axis, middle - X, longest -> Y? (Can’t seem to find ref to this in the manuals).
Phew! Now built and tested - V good guides and support - many thanks!
Best,
Phil.
Ok - Panic over - LED still not lit - I stupidly had a cable connected wrongly. Device is now working in X, Y and Y correctly and with correct parity.
OK - up to now - Just testing the X jog. I notice that the RHS (when viewed from the router side (front)) stepper motor red LED next to the 4-way out cable is not lit (the other three are) and the X gantry only moves on the LHS. (I’m only using small +/- jogs here to make sure I don’t damage anything). I also notice that, when, the duet is off, I can rotate both X screw drives gently by hand. When the Duet is on both seem to be locked. Is there anything I can do to test/rectify this? - do you need any further info?
Label ‘outward’? I assume means label side is not next to mount. I.e. can be seen when the assembly is laid on the bolt heads?
Quick follow-up on limit switches: I note switches are already wired up - great! Is there any significance in the differing wiring lengths? E.g. Shortest -> Z axis, middle - X, longest -> Y? (Can’t seem to find ref to this in the manuals).
Phil.
I cannot find the limit switches in the shipping boxes - where are they supposed to be please?
Cheers,
Phil