User avatar

Options

What g-codes are supported by the v2.2 WorkBee (Duet)?

I’m trying to drill 5mm holes in job (using 5mm end mlll) - my CAM software (FreeCAD) uses G81, G83 codes for this - which apparently are unsupported - what could I substitute for these?

Many thanks,

Phil.

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Most Helpful Answer
User avatar

Options

Hi Phil,

A full list of G-Code supported can be found here: https://duet3d.dozuki.com/Wiki/Gcode

You CAM program should be able to output them just using G1, G2, G3 moves.

Best Regards

Ryan Lock

Was this answer helpful?

Yes No
Score 1

Comments:

Ryan, many thanks for this - v. useful.

Cheers,

Phil.

by

Add a comment

Add your answer

Author avatar Phil Hughes` will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 680