Help
STEPHEN DALTON
@larchie
STEPHEN DALTON
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 12/01/2020 | |
| 1 | Reputation |
|---|---|
| 0 | Solutions |
| 0 | Guides |
| Member Since 12/01/2020 | |
why didn’t you say to route the wire through the drag chain before, when the drag chain is being installed? Even a note about would have been good?
Wouldn’t it be much easier to add this part when you’re building the Y plates? Very difficult to get to the bolts as it is. Not impossible, but unnecessarily fiddly.
Also, why does it have to be a 20mm bolt here? Given the difficulty getting to it, it would surely make more sense to not have to wind in 5mm of unnecessary bolt through a nyloc nut?
the diagram doesn’t match the instructions , which makes it very hard to do this step as you can’t figure out the orientation of the part until it’s built. I came here from the main component link.
You have 2 sets of 3 wheels enclosed by 2 plates, and the 2 sets of 2 wheels are unbounded, but in fact the built component is the other way round as far as I can tell.