The most likely cause of the flickering is something has not been completed correctly from Steps 1-8. So you are on the latest version WorkBee Control, but still on the old firmware on the board.[br]
[br]
We need to revert your WorkBee Control so you can start the firmware update guide again.[br]
[br]
Please follow these steps:[br]
- Turn off the machine[br]
- Remove the SD Card[br]
- Delete the www folder[br]
- Download and extract this www folder: ++[link|https://ooznest.co.uk/wp-content/uploads/2023/02/www.zip|https://ooznest.co.uk/wp-content/uploads/2023/02/www.zip]++[br]
- Put the extracted www folder onto the SD Card[br]
- Insert the SD Card back into the controller[br]
- Turn the machine on[br]
- Open WorkBee Control[br]
- Start the update firmware guide again: ++[guide|240]++[br]
- Make sure you follow every step carefully and fully as there are checks to make sure each step is completed.[br]
Please get in touch with any queries.