User avatar

Options

Is there a default password when using YAT to connect to a Duet2?

I can connect to the Duet 2 using YAT and IP address, but it's asking for a password to connect to the machine - Is there a default password or do I need to reset the board if the password is not known

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
User avatar

Options

Hi Nick,

Thanks for your message.

There should be no password. Can you send a screenshot of where it is asking for the password please?

Was this answer helpful?

Yes No
Score 0

Comments:

Hi Robert ... thanks for your reply.

I've actually found the cause of the issue - the config.g file had password set in it, It's a 2nd user Z1 which i believe was used on a network and the password is required when accessing the Duet over a network connection ??

However, as I'm new to this, is there a default config.g file that can be used initially for the machine (1000 x 1500) ?

Thnaks

Nick

by

Hi Nick,

Thanks for your message.

Ok, are able to connect to it now?

by

Hi Robert ... yes I can connect now but would like to know if there is a default config.g file available ?. The one on the machine seems to have incorrect parameters for a 1000 x 1500 Z1

Thanks

Nick

by

Hi Nick,

You just need to do Step 3 here: 2. Testing Your WorkBee

by

Add a comment

Add your answer

Author avatar Nick King will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 21

All Time: 28