User avatar

Options

Square end 2 Flute and 7mm MDF cut

Hi there, I want to clear an area of MDF to create a template. I am using the Ooznest supplied Square end 2 flute up cut 1/4"x1/4"x1/2"x5/2 and I am going to be 7mm deep on the Z axis cutting through the MDF. my question is could you please suggest feed rate, RPM and stepover margins for this?

Answered! View the answer I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
Chosen Solution
User avatar

Options

Hi John,

I would recommend 2-5mm passdepth, 2-2.5kmm/min feed rate, and 17-20k RPM as a starting point

Was this answer helpful?

Yes No
Score 0

Comments:

Although Carveco was very unhelpful using these settings it worked out fine with some adjustments from the workbee dashboard , board is now planed and ready, Thanks

by

Add a comment

Add your answer

Author avatar JohnM will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 19