Touch probe set up in Machine Specific
Hi, trying to set up my touch probe. I have no tab to enable the touch probe on the machine specific page. Duet Web Control 2.0.7. The board is 1.02 and Duet WiFi Server Version 1.23. Not sure if that is all relevant, Iv just installed the machine and uploaded latest software version… I think, thanks for your help in advance…
Is this a worthwhile discussion?
Score
0
Hi Rich,
Thank you for your guidance, my web interface is now updated and looking good. Thanks again, all the best, Nick
by Nick
Hi Rich, thanks for you help with the web control, it’s all looking good now. My machine home position is not showing 0 on any of the axis. Is this right and the same as yours? It as though the front left of my machine is the zero…
thanks, Nick
by Nick
Does the machine move toward home? Mine just moves to the rear right of the machine (looking from the router) after you click the home button on the dashboard. It homes z first, then x and y. Make sure the limit switches are working ok first and the direction of travel is correct.
Rich.
by Richard Rogers
This bit covers the process
4. Testing Your WorkBee
Rich
by Richard Rogers
Hi Rich, all the travel directions are as per testing guide, with the machine home back right. Once homed the machine position reads 1300 1250 94. The limit switches have been changed to normally open as the machine would not home previously... many thanks,
Nick
by Nick
Show 2 more comments