Z stop Pins missing from Duet 2 Ethernet
Has anyone had an issue where they have been unable to connect the Z stop as the pins are not present on the Duet 2 board. There is just a gap where the three pins should be. I am guessing this is a manufacturing fault?
Is this a good question?
Score
0
Not an issue I encountered - all of the sockets on the board had the required pins - and had a very positive bind with the connector. (Mine is wifi - but I don't think that will make a difference)
by Rob Say
Hi Rob,
I have removed the Duet 2 from the workbee and the back of the board does not have any evidence of pins being soldered in the zstop position. I believe the plug which is missing is a Molex KK type (same as the other 3 pin plugs in that row). I think I have a board which appears to have missed QA at the factory (very fustrating).
by Steve Gerry