Can you please elaborate on the meaning of “…until the motor clicks over.” in the Tensioning the ACME Screws section of the Testing Your Workbee guide? Also, is the procedure a one-time necessity or does it have to be repeated under specific conditions? Thanks.
Is this a good question?
Hi Bruno,
With the motors powered, when you tension the lead screws, you will fill the resistance build, and then a click, and back to minimal resistance again. Just before it clicks, is where the tension should be set.
Was this answer helpful?
Can I assume that it's a fairly audible click and I won't miss it?
@bb2020 Yes, you should feel it too
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 1
All Time: 75
