User avatar

Options

Unable to access web interface after update to config.g.override

To connect an emergency stop I addied the following to config-user-settings.g:

  1. ; Configure Software Emergency Stop
  2. M950 J1 C"!e1stop" ; Configure Pin
  3. M581 P1 T0 S0 ; Configure External Emergency Stop
  4. M582 T0 ; Check External Trigger

After a reboot, the web interface shows an orange button centre screen that says press to restart.

And that’s it!

I cannot access the web interface to try and reverse the change.

I can connect using YAT but have no idea if I can use YAT to fix this.

Any suggestions?

Thanks,

Tony

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

2 Answers

Filter by:
Most Helpful Newest Oldest
User avatar

Options

Hi Tony,

Thanks for your question. I am guessing the command must be wrong for your estop.

Push your emergency stop in, will it connect then?

Was this answer helpful?

Yes No
Score 0
Add a comment
User avatar

Options

Hi Robert, I have tried that - didn’t work unfortunately.

Have a horrible feeling I might need to re-image the SD card.

Do you know where I might get an image?

Thanks,

Tony

Was this answer helpful?

Yes No
Score 0

Comments:

Hi Tony,

Before doing that, put the SD Card into your computer. Can the computer read it?

If so, take the commands you added out, then put the SD Card back into the controller and try again.

by

Add a comment

Add your answer

Author avatar Tony will be eternally grateful.
View Statistics:

Past 24 Hours: 1

Past 7 Days: 1

Past 30 Days: 1

All Time: 61