User avatar

Options

Z Depth changes mid job.

I am running a G code on my WorkBee from a wifi Duet 2 contoller. On one G code, for a parallel cut, the Z depth strangely steps down by about 6.7mm after 1500 lines into the program and carries on at this new depth?

To try to resolve this, I set up the job again in Fusion and ran a simulation, this appears to be fine.

I then had a look at the code in G Code viewer, which appears fine also and shows no glitches.

I have now run the job again and the same happened at the same point in the job?

Can anyone advise please as this is starting to make face twitch?

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

1 Answer

Filter by:
Most Helpful Newest Oldest
User avatar

Options

Hi Shaun,

Thanks for your question.

That is strange, it should drop down without a command for it.
Can you email us the CAM and G-Code file?

Was this answer helpful?

Yes No
Score 0

Comments:

Hello Robert. Thank you for responding, it is appreciated. This issue has me completely puzzled. Do you have an email address to send the G-code file to.

by

Hi Shaun,

Please send it to help@ooznest.co.uk along with your order id.

by

Add a comment

Add your answer

Author avatar Shaun Woods will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 49