Skip to main content

v1.2

Minor Versionm

by Ryan Christy

  1. You are going to need our Motor Wire and Limit Switch Cheat Sheet. We recommend printing it off!
    • You are going to need our Motor Wire and Limit Switch Cheat Sheet. We recommend printing it off!

  2. Motor-Wire-6 is coming out of the Moving End of Drag-Chain-X. Feed Motor-Wire-6 through the Drag-Chain-Mount and plug it into the pigtail on the Z-Axis Stepper-Motor.
    • Motor-Wire-6 is coming out of the Moving End of Drag-Chain-X.

    • Feed Motor-Wire-6 through the Drag-Chain-Mount and plug it into the pigtail on the Z-Axis Stepper-Motor.

    • Feed the wire from Limit-Switch-2 through the Drag-Chain-Mount and then through Drag-Chain-X so it comes out the Fixed End.

    • Secure the Limit-Switch-2 wire and Motor-Wire-6 together to the Drag-Chain-Mount using a small cable tie as in Image 2.

    • Make sure there is enough slack on Motor-Wire-6 for the full travel of the Z-Axis.

    • Any unneeded slack in both these wires should be pulled out at the Fixed End of the Drag-Chain-X.

    • If you have the Touch Probe you can route that wire through Drag-Chain-X like Step 4 of Assembling Your Original WorkBee XYZ Touch Probe

    • Secure the wire to the Drag-Chain-Mount using a small cable tie. Then secure it along Motor-Wire-6.

  3. Motor-Wire-5 is coming out of the Fixed End of Drag-Chain-Y.
    • Motor-Wire-5 is coming out of the Fixed End of Drag-Chain-Y.

    • Tuck this wire into the bottom slot of Extrusion-A

    • Plug it into the right Y-Axis Stepper-Motor (If looking from the front)

    • Motor-Wire-4 is coming out of the Fixed End of Drag-Chain-Y.

    • Plug it into the left Y-Axis Stepper-Motor (If looking from the front)

    • Any slack in both these wires should be pulled out at the Moving End of the Drag-Chain-Y.

  4. Plug Motor-Wire-3 into the X-Axis Stepper-Motor.
    • Plug Motor-Wire-3 into the X-Axis Stepper-Motor.

    • Leave it hanging for now.

  5. That is all the wires routed. Now time to plug it all in!
    • That is all the wires routed. Now time to plug it all in!

    • Guide Complete - Proceed to 5. Controller

Conclusion

Thanks for following the guide. Any issues, please contact us!

12 other people completed this guide.

Ryan Christy

Member since: 10/31/2018

20,052 Reputation

99 Guides authored

0 Comments

Add Comment

View Statistics:

Past 24 Hours: 10

Past 7 Days: 41

Past 30 Days: 217

All Time: 979