sales@badgerandbowl.com

Yes Robert they are square my other question is are there fixings supplied to screw it down or can you recommend what fixings to use??

Many thanks

ok an add on to my last post…do i have to screw the bed down to my workbench to get this square?

if so what with?

ok i’m having real problems squaring up diagonal, so i bought a engineers square checked the two outside extrusions for square and they look spot on, i have 80mm on each 4 corners as per instructions i measured these with digital callipers but still i’m getting a diagonal measurement of one corner to the other 1803mm the other corners read 1796mm so i’m 7mm out of square.

i have tried for 5 hours to correct this checking everything for length and all’s good, i have a 1500x1000 machine. my workbench is flat and level, really need some advise and help.

regards mervyn

Can you tell me why my Extrusion-D bottom end only have three threaded holes and not 4 in the Extrusion-D so i cannot fit the bottom plate as it looks like this has not been tapped out, very annoying as i have a day off work to build rest of machine and now i cannot continue. am i missing something or am i right

many thanks Robert so i take it Robert this is the latest version? with the link you provided?

I have commented on further instru tions about the nut blocks each time it mentions 3mm spacers I don't have these in my packages only 9mm and 6mm no 3mm spacers, can someone clear this up for me before I build any futher.

Regards merv

Instructions below as per listed

On each bolt, in-between the ACME-Nut-Block and Y-Plate, there should be an Aluminium-Spacer-3mm and a Precision-Shim….???????

your saying that on each bolt there should be an Aluminium-Spacer-3mm and a Precision-Shim between the nut block and z plate i cannot find these 3mm spacers within the packages can you throw some light on this please. instructions also saying on the next step Step 4 X ACME Nut Blocks that 3mm spacers are used again I have checked all boxes and i don’t have these, I have also watched two youtube builds on the Z1+ v1.0 and they dont mention anything about the 3mm spacers and shims.

your saying that on each bolt there should be an Aluminium-Spacer-3mm and a Precision-Shim between the nut block and z plate i cannot find these 3mm spacers within the packages can you throw some light on this please.