Adam J Barnett

I can’t find this at all. Then when I refreshed the page, it went away and is only a blank white page now.

I had to also set the Default Gateway manually here.

I tried setting up in windows, and failed. Trying in OSX now and I got an error, it said this “RepRapFirmware for Duet 2 WiFi/Ethernet Version 2.02(RTOS) dated 2018-12-24b1

                                                                             Executing config.g...Error: Bad command: FOR TESTING ONLY! USE https://configurator.reprapfirmware.org/ to generate configuration files for your printer!

                                                                      Warning: Heater 0 appears to be over-powered. If left on at full power, its temperature

???? What do I do?????

I agree. I’m dead in the water here too.

*You’re - Sorry, I had to.

Should I have the ethernet cable plugged in now? I’m getting the same error as above.

The routing of the ethernet cable should have been brought up when the Y-Cable chain was filled with wires. This is so hard to add to the mix now.

Should I be running the power cord to the router through here right now too?

All the 40mm spacers that came in my kit are measuring 38mm. Is this ok? Because now the stepper motor doesn’t sit flat, it’s off by 2mm!

This was slightly difficult. I have long T handled Allen wrenches with ball ends so that helped. But I agree this step should be completed right before or after attaching the stepper motor.