Jonez

Hello I’m having multiple problems with my machine after upgraded to screw drive. 1- Axis-Y left side and right side were...

Hello Recently bought a Workbee 1500 x 1500 used, I believe is a V1 because it has belts. After doing all the...

The weird part is that, if is the cable broken/shorted or anything why still works? And why the directions randomly is changing? And yes one of the connectors looks weird, maybe burn, but still working nevertheless. And if the cable of Axis Y why Axis X is affected? Fans are working fine. Do you think that it could be actually the board? Thanks.

Hi Robert For some reason can’t answer your question, can’t see my post! Anyway. So I'm attaching a picture of my File Management as you suggested and the RepRapFirmaware it says: Firmware: RepRapFirmware for Duet 2 WiFi/Ethernet 3.3 (2021-06-15). Did try the Update again and the Axis-Y homing problem is solved (sort of), but I still get some errors. For example, Axis-X if I jog it to one direction (say left), it will go like say 4-5 times then the following goes Right, and then after that might still go Left again, completely random movement. Also I get this “sometimes”: Warning: motor phase B may be disconneted reported by driver(s) 0. With Axis-Y theres is a similar problem, when jogging it, both drivers might move same direction, but then they might go opposite directions and then same direction again, complety random. When homing all axis moves as it should (but it depends on the last movement, if the last movement was in a wrong direction then the specific Axis will home to the opposite direction....

Hello Robert, thanks for your answer. I’ve done this already and nope, no cookie. I will try again just to double check that I did everything right, and will confirm if it did help or not. J.