I am using Workbee Z1 and after loading up a file, the router does not move. I have reset but still get same problem. The error message is M32 "0:gcodes/cherry skim.gcode" with Response too long. Can you advise please.
Is this a good question?
Hi Allen,
Thanks for your message.
Sorry to hear about the issues you are having. If you go to Control > Console you can see the full error.
We have made a guide on solving the Outside Machine Limits error here: Outside Machine Limits Troubleshooting
Give that a read and let me know if it does not solve your issue.
(Please note if you have an M3 error, this error is not the reason why your job is not running. The M3 error is just trying to set the speed on a spindle. But with the WorkBee we use manual speed control router heads.)
Was this answer helpful?
Once alerted to the issue I reran the same gcode on a thinner blank and that worked fine. I then reduced the 'Z gap above material' in materials setup and it worked fine.
Was this answer helpful?
Past 24 Hours: 0
Past 7 Days: 3
Past 30 Days: 13
All Time: 68
