User avatar

Options

G0/G1 Machine out of limits

I have just got my 1000mm x 1000mm Ooznest workbe up and working and managed to produce my first couple of signs using Fusion and they came out quite well.  Would have faced a new spoiler board first but cannot get it to work. I keep getting a G0/G1 Machine out of limits error. I have tried changing the heights as mentioned on the support pages and have even the size of the board in fusion360 but nothing works. The system files and the firmware have all been updated to latest versions as part of the machine build.

Answer this question I have this problem too

Is this a good question?

Yes No
Score 0
Add a comment

3 Answers

Filter by:
Most Helpful Newest Oldest
User avatar

Options

Hi Steve,

Thanks for your question. Have you seen this page: I keep getting 'Outside Machine Limits' Error?

This error is normally due to one of the errors outlined on that page.

Best Regards

Robert

Was this answer helpful?

Yes No
Score 0
Add a comment
User avatar

Options

I have tried the fix as mentioned in the article and its still an issue. If you read my initial question it clearly says I have been to the support pages and have adjusted the heights. I can also confirm the job is within the size parameters.

Was this answer helpful?

Yes No
Score 0

Comments:

Hi Steve,

If you can send screenshots of the Work & Machine Coordinates as well as your G-Code file to ooznest.co.uk/help we can work out what is going wrong.

Best Regards

Robert

by

Add a comment
User avatar

Options

Hello how was this resolved please as I have the same problem. I was cutting and ran two out of my three codes on the same price of work and it ran them perfectly, but with the third I'm now getting this error. Thank you.

Was this answer helpful?

Yes No
Score 0

Comments:

Thank you, I've managed to sort it out. It was to do with the Z axis. I was asking it to go higher that it could. I checked and changed each setting to find it.

by

Add a comment

Add your answer

Author avatar Steve Gerry will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 0

Past 30 Days: 0

All Time: 121