Hello,
I know it’s not very relative to the Workbee, but I’m struggling to find a solution to avoid tenon marks during contour cut on my 1000X1000. I’ve tried 3d tenons, but still, any contour that I try leave marks at in/out of tenons.
Thanks for your help
Guillaume
Is this a good question?
Hi Guillaume,
Thanks for your question
Can we get a picture of the marks which are being left? Do you mean tabs not tenons?
What CAM Software are you using?
Best Regards
Robert
Was this answer helpful?
Hello Robert,
Yes indeed it’s tabs sorry for my english, I’m currently using Vcarve toolpaths, haven’t tried with Fusion yet, Vcarve is doing the job for the rest, the only reccurent problem that I have is these tabs marks, even with 3D tabs, during contour. I tried several types of 3.17mm end-mills. Please finf pictures attached.
Thanks a lot for help. Best
Guillaume
Was this answer helpful?
Hi Guillaume, these marks are caused when the machine comes to an abrupt stop. 3D Marks help alleviate this but is not going to stop. I would try doing a finishing pass to remove them marks.
Ok thank you very much for your help, I'll try both of them
Thx
Guillaume
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 87
