Guillaume

Hello, I’m looking for a way to Set X and Y in a Macro, just like when SET X and SET Y are pushed. Which code should I use...

Hello, I have an offset problem when I Probe corners with the touch probe; (1) If I mark a cross on a square piece, and I...

Hello, I have an Original Workbee 1000X1000 bought in early 2021, and there’s a possible upgrade with the Thrust Bearing...

Hello, I have a weird problem that I can’t figure out, after calibrating X steps/mm, if I pocket a square of 40mm the...

Hello, I know it’s not very relative to the Workbee, but I’m struggling to find a solution to avoid tenon marks during...

Hello, Is there any possibility to add a Laser Kit to Workbee (1000X1000) ? I’m looking for a non expensive product, not...

Hello, Is it possible to reset, meaning emptying the several Work Coordinate Selection Presets 1 to 9, I can’t see any...

Hello, I have issues calibrating Y Axis on a 1000x1000, I followed the Step/mm Guide, reporting correct values in...

Hello, Have you by any chance gone forward with your project ? I’m also interested, but I’m confused with the addition of additional axis in configuration. Thanks Guillaume

Thanks for you answer, I will re check calibration to see if it’s ok with this Guillaume

Thanks for the tip Robert

Hi Robert, At least 1mm on small dimensions, growing in bigger pieces. If I modify th etouch probe settings could I correct that ? Thanks Guillaume

Thanks Robert, there is two version available, is a Workbee from Feb 2021 is V 2.3 or V 2.1 ? Thanks Guillaume

Hi Robert, No, everything is straight on CAM side. Thanks Guillaume

Hi Robert, Thanks for help. So calibrated again using a contour, which is ok, and I’ve done a pocket of same dimensions on these settings, with the correct endmill value, and I still have a 0.60mm difference (positive in the pocket) between these toolpaths. I guess at this point I can do nothing more to improve that. Thanks Guillaume

Hi Robert, I'm using a 6mm endmill, which is actually 5.96 with a digital caliper. Is these 0.04 are accounting, I guess so. When you are calibrating, is it better using a contour or a pocket to calibrate ? Thanks for your help Guillaume

Hello Robert, Yes indeed it’s tabs sorry for my english, I’m currently using Vcarve toolpaths, haven’t tried with Fusion yet, Vcarve is doing the job for the rest, the only reccurent problem that I have is these tabs marks, even with 3D tabs, during contour. I tried several types of 3.17mm end-mills. Please finf pictures attached. Thanks a lot for help. Best Guillaume

Hi Robert, I’ve made a new test, on 3x 40x40 Squares, and from right to left: (1) Square 1 is X40.45 and Y 40.30 (2) Square 2 is X40.40 and Y 40.30 (3) Square 3 is X40.38 and Y 40.30 Each time I modify settings, I’m under or over 40, never exactly 40. However, I’m using MDF for the tests, and I guess it’s not very accurate for testing. My tests are made with a 3.17mm Endmill. Thanks very much for your help Best Guillaume

Hello,

I just ordered a 1000X1000 model, and I’m struggling a little bit to understand exactly the possible cut depth allowed in 47mm. If I use a 20mm spoilerboard mounted on original spoilerboard support, what is the cut depth left ?

Thanks

Guillaume