Skip to main content

Changing z during job

Say I’ve started my job and find that it’s skimming just above the surface of the wood. Is it possible to lower the z value by increments during the job until I hear it engage with the surface and then stop and return to the start of the job with the new z value?

I mean without hitting the cancel job button and having to home axis all over again.

In this instance, I’m surfacing the board so can’t do a corner probe but if this happens despite probing the corner?

Answered! View the answer I have this problem too

Is this a good question?

Score 0
Add a comment

2 Answers

Chosen Solution

Hi,

As Peter said above, the Red Arrow on this step here allows you to do that: WorkBee Control Overview

Robert

Was this answer helpful?

Score 0
Add a comment

Step 5 of this guide allows for altering Z height if you are using Workbee Control. Not sure if you can do it during a run though, as not at my CNC.

WorkBee Control Overview

Was this answer helpful?

Score 0
Add a comment

Add your answer

Robert Thompson will be eternally grateful.
View Statistics:

Past 24 Hours: 0

Past 7 Days: 1

Past 30 Days: 6

All Time: 28