I have an older WorkBee, and recently upgraded the firmware - I am unable to home Y. When the axis is set to “M569 P1 S1” the Y screws will not synchronize and seem to go in opposite directions; If I try S0 then Y movement is synchronized but go in the opposite what it should be.
Is this a good question?
I was able to resolve the problem by changing “M569 P3” from S0 to S1 in “config-drives.g“
Thank you for pointing me in the proper direction.
Was this answer helpful?
Hi Larry,
Is yours a belt drive WorkBee?
When you upgraded did you complete Step 12 here: How To Update WorkBee Firmware V1.0.7 > V3.3.0-1.2
Robert
Was this answer helpful?
It is entirely screw-drive... I missed the warning, and did screw-drive section... Are the original files available to reupload?
Looking at the files uploaded in Step 12, I have adjusted those values through the web UI. I have also validated the wire terminations...
I still have the problem
Hi Larry,
If you are machine is all screw-drive, then Step 12 should not be completed.
Please redo Step 11 to put it right: How To Update WorkBee Firmware V1.0.7 > V3.3.0-1.2
Best Regards
Robert
Past 24 Hours: 0
Past 7 Days: 0
Past 30 Days: 0
All Time: 77
