William Walshaw

In my 1000mm x 1500mm machine there are no Single Universal Brackets only Double ones and six all together. Will I need these for something else later? Or can I use them instead.

Good to see its not just me then……

Did anyone else find they had to fold the wire terminals flat so the C beam could fit? Hope that will still operate. Any ideas?

Did you find that when you put yours together you had to bend the wires completely flat so they would not rub?

It would be great to mention the Z axis limit switch and wire in this description as they need moving out of the way to do the alignment test. I assume at a later date that the C section will not rub the wires……perhaps this is explained later.

I have the 1500mm by 1000mm machine with two long lead screws and one intermediate and lastly tiny screw.

With no labels on the screws I assume the two long ones are Y axis and intermediate is X axis……was unsure of this assumption.

Nice and straight forward this one.

They do need pushing in until they click.

Not too sure what to do next……..