Daniel Cox

oh lord, i actually did it! thanks guys its been emotional!

so when and how do I attach the router?

Seriously!? How comes this isn't in the instructions anywhere?

thanks so much! turns out technical support had got straight back to me, my apologies. I had a problem syncing my email to my phone. Cheers guys, great support thanks for your help!

I’m putting this comment in as a cry for help. I cannot thread my wires through the hole(s) mentioned, my wires came attached to the switch, on the other end of the wires is the connector which is too big to thread through the hole(s). Can i remove this connector? Can a remove the wires from the swith? I’m scared to try and dont want to break anything. I’ve tried technical support and they’re not getting back to me. PLEASE HELP!

Pete is right! plus yes the ends of the cables have changed

ouch my fingers

Found this difficult. Raise the machine up so you can get your head under to sight the bolts. Found it easiest after fitting the tee nuts to line them up then push the bolts upward to receive the spoiler support then drop the spoiler support onto the tee nuts whilst still pushing them up, let the spoiler drop flush with the rest of the frame. Then holding the bolts in place tighten them one by one. Hope this helps and makes sense.

Are you guys fitting the t-nuts to the c extrusion? you’re supposed to be fitting them to the v-slot. The ends of the v-slot are exposed so you don’t need to remove any of the end plates regardless if you read ahead or not.

thanks for the tip paul, made it easy.