The Limit Switches are delayed in WorkBee Control?
The Limit Switch on the WorkBee updates in WorkBee Control after a couple of seconds?
Is this a good question?
Score
0
30
1 Answer
Chosen Solution
It is normal for there to be a delay between pressing the limit switch and the status being updated in WorkBee Control.
This is because WorkBee Control only polls for the status every couple of seconds.
Please do not be concerned, the board itself will stop the motor instantaneously after it has been switched.
You can test this, as there is a red light on the board which will show when the limit switch is pressed.
Was this answer helpful?
Score
0
Hi Ryan -
ive just completed my build, and see that my red lights are active all the time, unless i press the switch, and then the lights go out. Because of this I know they are connected, but something up here, as its the opposite of what you say should be happening. I also notice that the switches don't stop the machine movement at all.
Any ideas how to solve this?
Steve
by STEPHEN DALTON
@larchie Thanks for your comment. If you complete this guide here it should solve your issue: How To Invert Limit Switches
Robert
by Robert