Adrian Hardy

I have an ESP-12S WiFi module, with nowhere to attach the antenna?

Difficulty moderate, time required 1hr 10 mins? What did I miss?

How do you route the z-axis limit switch wire, as it wants to foul between the chain and the a axis plate…?

Turning over the bolts makes a lot of sense as far as preventing cable wear…

I used a piece of plastic conduit cover to the same effect.

Y axis drag chain is the longer of the two. It doesn’t tell you that anywhere else!

Need to make sure that the bolt sticks through at least 5mm, so make sure you drill countersink deep enough.

drop-in tee-nuts are bloody useless, gave up and put in the normal slide-in tee-nuts, works a thousand times better.

just unscrew the angle joint between beams and remove the end cover, slide in your tees and re-assemble. it will save you hours of buggering around.

Useful, thank-you.

Is worth looking at the ‘wire routing - step 2’ section first, as the z-limit switch wire needs to be routed through the front plate of its front-plate. Do this before assembling a axis onto c-beam.

On my pack the bolts are M3-socket-head-bolt-10mm