Please be very careful when carry out the following steps. Check there is enough travel for the machine to carry out these steps. If there isn't enough travel either reduce the jog amount, or move in the other direction.

With the machine roughly in the middle of travel on all its axis. Connect to your WorkBee in WorkBee Control.

Jog the machine 10mm in the positive X Direction by Press 'X+10'. The machine should move 10mm to the right.

Jog the machine 10mm in the positive Y Direction by Press 'Y+10'. The machine should move 10mm to the away from the front.

Jog the machine 5mm in the positive Z Direction by Press 'Z+5'. The machine should move 5mm upwards.

If any of the axis are travelling in the incorrect direction please refer to this guide to rectify it: https://learn.ooznest.co.uk/Guide/Change+Axis+Travel+Direction/21?lang=en

For the Z-Axis Motor Wire that is inside the X-Drag-Chain, connect it to the pigtail on Z-Axis stepper motor. Making sure there is enough slack for the full travel of the Z-Axis shown in red, secure the wire to the X-Drag-Moving-End-Mount using a Cable-Tie-Small, shown by the small blue circle above.

The lead on the X-Axis limit switch should be secured to the V-Slot-2040-750mm using a Cable-Tie-Large at the position shown by the blue oval above. Then run the lead along to the other end of V-Slot-2040-750mm - it can be tucked into one of the slots.