david.birch@essex.ac.uk

Hurrah, that’s everything assembled! now to put this to work.

Doors are a very tight fit, would recommend more clearance and a foam seal?

Note that you only need 10 of these to be assembled like this

presumably these are the 10mm bolts

Don’t forget to feed the wire through the cable tie you inserted earlier

Pro tip - the stick of the supplied lollypop can be used to move the washer within each wheel so that it the bolt goes through. I assume that’s why its enclosed ;)

Would recommend assembling both of these plates at the same time - lay them down flat on the table as shown in the first figure of step 4 - with the two rectangular holes close together. Follow the instructions for the right hand plate and mirror for the left hand plate (which will be the one you add the motor to).

These are (rightly) a hard press fit. I used a rubber mallet to (*lightly*) tap the bearings in fully place.