My Favorite Guides
Questions
-
Special Eccentric Adjustment Spanner.I believe you now send out a special spanner for the eccentrics adjustment. I have a Ooznest Workbee V1 screw? Will it fit...
Answers
-
Answer to "Connecting to controller without internet"Let the Duet Controller send the Wi-Fi signal as an Access Point? This may help? 2. Connecting your Duet to a Network - Access Point
-
Answer to "Workbee not executing code correctly"Shouldn't you be using the Ooznest Duet Arcs (mm) (*.gcode) post-processor?
-
Answer to "How to pause workbee so can change the tool for finishing pass"And reset the Z zero after each tool change. ;o)
-
Answer to "Workbee Z1 Assembly Guide"If you open the chapter that you want, click on the 3 dots upper right, then you can save as a PDF.
-
Answer to "new duet 2 wifi controller which guide do I use"Brian, instead of putting http://workbee.local/ , try putting the IP address that you got from YAT into the address bar.
-
Answer to "What is the purpose of the Calibration Endmill?"Oooooh!! What dastardly deeds are afoot at Ooznest?
-
Answer to "My round holes are not coming round"Did you calibrate your x, y, z-axis? If not, this may help https://www.youtube.com/watch?v=PsCiCDZe...
-
Answer to "Instruction pictures not loading"Seems rectified now!
-
Answer to "Changing z during job"Step 5 of this guide allows for altering Z height if you are using Workbee Control. Not sure if you can do it during a run though, as not at my CNC. WorkBee Control Overview
-
Answer to "Is the "Stop Button" available as an upgrade?"Most Emergency Stop buttons will work. I did mine this way… How To Connect A Software Emergency Stop Button
Guide Comments
Reputation over time
Reputation Breakdown
Event | Count | Delta |
---|---|---|
Post was voted up | 7 | 84 |
Accepted answer | 1 | 10 |
22
Wow! So much easier than the previous method. So, so glad I held off and did it this way. Works a treat.
….and I’m not sure if this is what the customisation file is for? Does this override the standard settings in the config files?
Adding the machine sizes is good, but if like me, my end stop settings vary from the standard and I get a few mm extra travel, I need to change the maxima’s. Adding which parts may require changing would help?
Also, if the calibration has been done, this needs to be changed in M92 part?
I’ve not done the update yet, so apologies if I got it wrong. ;o)