Tezza

PLEASE can anyone help? I am trying to update firmware using 2.07 to 3.3 guide. I am currently sat for over an hour...

Hi, my workbee is in access point. Is this a problem for firmware 1.07 to 3.3? Also is the update done over wifi or do I...

Just noticed after trying to use the height reference tool to aid some marking out. The 17.60mm is indeed 17.60mm but the...

Has anyone tried to adjust the eccentric nuts on the “Y” plates after completing their build.with spoil board fitted and...

Got my new workbee built at last. Was I right to ignore the section that said to update to latest firmware? Surely the kit...

Just started using my workbee and wondered which is the best post to use with vcarve pro, duet arcs or grbl?

When assembling the X axis moving end assembly on a screw drive workbee, why not have the nuts underneath the bracket (no...

Does an allowance have to be made for machine home position if dust shoe is fitted. If so how much?

I will hopefully be taking delivery of my 1000 x 1000 workbee in early May. After reading quite a few posts on various...

Workbee ordered. I have a fairly high spec, expensive, laptop for running cad/cam etc but don’t like the idea of...

Hi, the line marked on cutting tools usually denotes the “minimum” recommended insertion depth. You can insert bits further than this but I would avoid inserting past the flutes of the bit. Hope this helps.

Problem now sorted. After pressing upload, at some point my laptop dropped the connection to access point and connected to home wifi. I reconnected to access point IP and install completed ok. Had to do the same on step 9.zip. This is because during the install the connection is dropped and re-established automatically, my laptop default is home wifi, hence my problem. Hope this helps anyone else doing this update via access point mode.

Hi I use WD40 “DRY PTFE”

Hi Will, When you save your toolpaths the software will create separate files for each different tool that you specify. You will run each file individually within the web control interface. When one is complete you change your tool (remember to redo Z ) then run next file. When creating your job it’s a good idea to rename toolpaths to include the tool name to avoid confusion. Eg. Profile V60deg or pocket 6.35 etc. I don’t use imperial sizing as / symbols may cause problems. I call my 1/4” end mill 6.35mm. No disrespect but sounds like you really need to check out some basic cnc tutorials on the net.

I would like to hear from anyone with experience of this too.

Hi Will, what part of country do you live? Don’t post your full address here lol.