Is XYZ Lead Screw Or Ball Screw?
accepted 1 Answer
Toolpath errors when cutting
1 Answer
keep getting the following error message
2 Answers
Settings for Ooznest Solid Carbide Engraver – 2 Flute
discussion 1 Reply
X axis homes in wrong direction
discussion 4 Replies
workbee z1+ lost connection
1 Answer
Ethernet connection lost following disconnection
accepted 3 Answers
Increasing Z axis travel
accepted 1 Reply
motor phase A may be disconnected reported by driver(s) 1
discussion 1 Reply
Ethernet to USB adapter
1 Answer
Workbee Z1 loss of power
7 Answers
Wiring diagram workbee z1 +,
1 Answer
X axis is cutting 5mm long on all programs but not Y
discussion 1 Reply
X Axis Homing Position Accuracy
discussion 3 Replies
Using a Rotary with the workbee and duet original board
discussion 1 Reply
Z axis moving further down than it should on each pass
discussion 1 Reply