Ask
Learn How It Works Ask a Question
All Questions
Original WorkBee Z1+ Assembly Manual - V1.0

Original WorkBee Z1+ Assembly Manual - V1.0 questions

clear
Most Helpful
All Most Helpful Newest
All Questions
1 Answer

trying to home machine for first time.

1 Answer

User avatar

redrobinlabels@gmail.com 11

Commented

Commented by redrobinlabels@gmail.com

1 Reply

What is the best speeds and feeds surfacing?

discussion 1 Reply

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Reply

Z homing not repeatable

discussion 1 Reply

User avatar

Robert 24.2k

Commented

Commented by Robert

1 Answer

Attaching Katsu Router stage

accepted 1 Answer

User avatar

Dave Mooney 11

Answer accepted

Answer accepted by Dave Mooney

1 Answer

Why a 3mm offset in the Touch-Probe-Offset-Calculator.xls

1 Answer

User avatar

Robert 24.2k

Commented

Commented by Robert

1 Reply

low voltage error message

discussion 1 Reply

User avatar

Robert 24.2k

Commented

Commented by Robert

1 Answer

How to set the machine not to move after finishing the job

1 Answer

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Answer

Webserver timeout, not responding, but board responds to ping

1 Answer

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Reply

Y Axis squeak, possibly ACME nut blocks?

discussion 1 Reply

User avatar

Jonny Cantwell

Commented

Commented by Jonny Cantwell

1 Answer

What is the meaning of “...motor clicks over.”?

1 Answer

User avatar

Robert 24.2k

Commented

Commented by Robert

1 Reply

How to run automatic mesh compensation using router bit as probe?

discussion 1 Reply

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Reply

The use of alternative software

discussion 1 Reply

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Reply

Are there any recommended Z height modifications?

discussion 1 Reply

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Answer

Original Workbee Duet Kit limit switch mounts included?

1 Answer

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Answer

How do I give the Workbee a static IP address

1 Answer

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Answer

Matching steppers for the Original Workbee Duet Kit

1 Answer

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Answer

Z axis changing and not cutting deep enough

1 Answer

User avatar

Robert 24.2k

Commented

Commented by Robert

1 Answer

X Axis keeps jamming near the ends

1 Answer

User avatar

Robert 24.2k

Answered

Answered by Robert

1 Answer

Z stop Pins missing from Duet 2 Ethernet

accepted 1 Answer

User avatar

Steve Gerry 11

Answer accepted

Answer accepted by Steve Gerry

1 Answer

Machine bumps into Y gantry with dust shoe on

1 Answer

User avatar

Scott Smith

Commented

Commented by Scott Smith