How do Tool (Endmill) changes happen on the WorkBee?
accepted 1 Answer
My Ethernet WorkBee is not connecting when plugged directly into a com
accepted 1 Answer
How to Sync the Y-Axis Motors on a WorkBee?
accepted 1 Answer
Vibration and noise at idle
accepted 1 Answer
Swapping axes on a 1000x1500
accepted 1 Answer
The Wifi Module on my WorkBee is stuck in Idle Mode
accepted 1 Answer
Is there only one height the Spoilerboard can be positioned?
accepted 1 Answer
Is the WorkBee compatible with Linux Operating systems
accepted 1 Answer
What is the difference between Climb and Conventional cutting?
accepted 1 Answer
What is the difference between Up and Down Cut Endmills?
accepted 1 Answer
What are the X, Y & Z-axis of the WorkBee?
accepted 1 Answer
Can I use a 6mm endmill in my 1/4” collet?
accepted 1 Answer
limit switches are wired as show
1 Answer
Advice on enclosure for 1500x1500 unit
discussion 1 Reply
help with machine control
1 Answer
G0/G1 error code - help
discussion 1 Reply
How do I adjust the steps/mm on my Duet WorkBee?
discussion 1 Reply
Are these machines suitable for cutting mild steel?
discussion 1 Reply